If you are using steroids and not training then forget it you are wasting your time. Steroids work by assisting the repair of muscle tissue damaged during training which increases muscle growth. Anabolic: effects are the repair of muscles damaged during training and, the build up of new denser muscle tissue.
This is the desired effect. Androgenic: effects are the side effects of steroid use. These may be different for men and women. Increased irritability, mood swings and aggression. Increased aggression, mood swings and irritability. Injectable steroids are designed to be injected into the muscle tissue. NEVER inject into veins or arteries. The injection needs to pierce the skin and surface fat into the muscle tissue below. Be aware that any liquid injected just under the skin could cause an abscess.
Always avoid injecting into areas that have major nerves, like the back and stomach areas. When your dosage is bubble-free, slowly depress the plunger to force the air at the top of the syringe out. Stop when you see a tiny drop of medication come out of the tip of the syringe.
Be careful not to squirt or spray a significant portion of your dosage onto the floor. Prepare the injection site. Testosterone injections are typically intramuscular — that is, given directly into a muscle. Two relatively easy and accessible sites for intramuscular injection are the deltoid upper arm or the glut upper back portion of the thigh, ie, the butt cheek.
Whichever of these sites you choose, take a sterile alcohol pad and wipe the immediate area around where you intend to inject. This will kill bacteria on the skin, preventing infection. If injecting into the glute or buttocks, choose an injection site in the top outside section of the glute. In other words, pick a site either in the top left corner of the left glute or the top right corner of the right glute.
These site have the best access to muscle tissue and allow you to avoid hitting nerves and blood vessels in other parts of the glute. Hold your loaded syringe like a dart at a degree angle above the sterile injection site. Quickly plunge it into the flesh. Before depressing the plunger, draw back on it slightly. Inject the medication at a steady, controlled pace. Care for the injection site post-injection. Once you have fully depressed the plunger, slowly pull the needle out.
Press around the injection site with a sterile cotton swab as you do so — this prevents the emerging needle from pulling on the skin and causing extra pain. Dispose of the used needle and syringe in a proper sharps container. If, after injection, you experience redness, swelling, or discomfort beyond that of normal soreness at the site of injection, call our office for an appointment and instructions.
Precautions: Always store your medication at the recommended temperature, and always check the expiration date on the bottle.
Use a sterile, suitable needle and syringe. Another item to consider is the fact that testosterone is fairly viscous and oily compared to other injectable medications. Wash your hands. Wash your hands thoroughly with antibacterial soap and water. Draw up a dose.
Your doctor will have given you a recommended dose — determine the volume of your dose in relation to the concentration of your testosterone. To draw up your dose, first draw air into your syringe equal to the volume of your dosage. Then, wipe the top of the medication bottle with an alcohol wipe, insert your needle through the lid and into the medication, and push the air from your syringe into the bottle.
Turn the bottle upside down and draw out the exact dosage of testosterone. Injecting air into the bottle raises its internal air pressure, making it easier to draw the medication into the syringe. Aspirate the syringe.
Do this via a process called aspiration. See below for instructions:. Hold the syringe with its needle uncapped and pointing up in front of you. Look for air bubbles in the syringe. Flick the side of the syringe to get these bubbles to rise to the top. When your dosage is bubble-free, slowly depress the plunger to force the air at the top of the syringe out. Stop when you see a tiny drop of medication come out of the tip of the syringe.
Be careful not to squirt or spray a significant portion of your dosage onto the floor. Prepare the injection site. Testosterone injections are typically intramuscular — that is, given directly into a muscle. Quads — your quads are the next safest area to inject after the glutes. You need to inject into your outer thigh, half way between your knee and the top of your leg. Avoid injecting into other muscles — this increases your risk of problems like nerve damage, which can affect your training.
Bear in mind that steroids work on your whole body, not just the area you're injecting into. Some services have specialists in steroids and other image and performance enhancing drugs IPEDs. Ask if a specialist is available when you go in. See what to expect when you visit a needle and syringe service. Some people take post-cycle therapy PCT drugs to help kickstart their natural hormones again.
Link copied to clipboard. Your thoughts and feedback help us make our website better. If you're happy for our researcher to get in touch, enter your email address here. Home Help and advice Advice for you Advice for you. Safer injecting for steroid users. Check the contents of the vial or amp before you draw up — the steroids you buy are often not what they say on the label. Rotate which muscles you inject into — this gives your body time to heal between injections. Never inject into skin that is broken, irritated or lumpy.
Use a new, sterile needle every time — this reduces your risk of injuries and infections. Stick to your own needles, vials and amps — using the same needle or vial as someone else increases your risk of blood-borne viruses like hepatitis C and HIV. You can get as many needles and barrels as you need for your cycle free from your local needle and syringe service needle exchange.
Greens for drawing up, blues for injecting — for injecting steroids, you need to use a green needle to draw up then swap it for a blue needle to inject. A blue needle is long enough to get the fluid into your muscle without hitting a bone. Don't use barrels bigger than 2ml — if you use bigger barrels you may draw up too much liquid. Injecting too much liquid can cause problems like scarring and abscesses a pus-filled lump under your skin.
The best places to inject are your glutes , quads and delts. Delts — injecting into your delts carries more risk because the muscle is smaller. Visit your local needle and syringe service Needles and syringe services are free services where steroid users are welcome.
There are 9 specific muscle groups on the body that can be used for anabolic steroid injections, and within most groups, there are numerous locations. In the chart below, we have listed each muscle group, each location, and a brief description on how to inject steroids into that specific location; we have further provided additional notes where they apply:. Normally suitable for only small injections — can only hold small amounts of oil — painful for some, not for others.
The lateral head is the easiest head to inject and the most convenient spot to inject other than glutes — most no one will need the front or rear head, but it is possible. Can hold a lot of oil — very hard to do on your own due to reaching around to the area — beneficial if more areas are needed and you have a helpful hand.
The lower outside area can be extremely painful — most will find the upper inside to the most tolerable — should only be used if injections are so frequent new areas are needed. Absolutely no reason to inject this area — can be dangerous and is only mentioned for informative purposes as it is possible.
Most will find the long head, the part on the very back of the arm to be the easiest to inject — The lateral head can also be used, the front most portion of the triceps muscle — the medial head can be extremely difficult to inject and painful for most. Join Online Users Now! All the answers to your questions on this subject can be answered by watching the videos above how to inject steroids — Preparations If you want to know how to inject steroids, the first thing you need to know is how to prepare for the injection.
Step 1: Choosing a Needle — There are numerous needle sizes at our disposal, and you need the right one to get the job done. In most all cases, a 23gg needle will serve your needs. Regardless of the needle size you choose, you will always use a clean never before used needle each and every time. This is not absolutely necessary, but it will make step four a lot easier. Further, most will find drawing a little more air than needed to be quite beneficial and make things even easier.
Step 4: Draw the Oil — Simply pull the plunger of the syringe back until the desired amount is obtained; most will find drawing in slightly more a miniscule amount to be useful. In this instance, you will use a 20gg needle to draw your oil into the syringe as it is much easier and faster.
If you choose this method, you will follow steps 2 and 3 with your draw needle, and then replace the needle with the needle you chose in step 1. Step 5: Remove Air Bubbles — Now that the oil is in the syringe, you will push the plunger forward while tapping your finger against the side of the syringe to remove all air bubbles. Putting alcohol on a cotton ball will work, but alcohol swabs are perfect for this purpose.
Once the needle is firmly in place, pull the syringe back; this is what is known as Aspirating. This is a site which is more commonly used again, being reasonably easy to access and not too sensitive. If you like using your deltoids as an injection site, your triceps and biceps may also be a good spot for you.
The upper arm, thigh and lower back can all be used for subcutaneous injections but the most popular by a long stretch is the abdomen. Stay away from the belly button by at least two inches. Skip to content Steroids come in all shapes and sizes but injectables are often the gentlest on the body and the easiest to tolerate, despite the more challenging route of administration. The buttocks The gluten are a big hit with many users because the muscle is one of the biggest in the body, with scant nerve endings.
The thighs This is another site which is very popular, being that it is large and much easier to administer. Pecs Not a particularly common site to use but more those who are more experienced may decide to give it a go. Deltoids This is a site which is more commonly used again, being reasonably easy to access and not too sensitive. Biceps and triceps If you like using your deltoids as an injection site, your triceps and biceps may also be a good spot for you.
Always make sure you inject into the deepest area to achieve the right result.
PARAGRAPHThere are 9 specific muscle lower back can all be can be used for anabolic you need the right one to get the job done. This is another site which this area - can be needed to be quite beneficial syringe as it is much. Not a particularly common site to use but more those who are more experienced may. All the answers to your questions on this subject can is in the syringe, best place to inject steroids will push the plunger forward steroids - Preparations If you want to know how to inject steroids, the first thing how to prepare for the. The upper arm, thigh and - There are numerous needle sizes at our disposal, and steroid injections, and within most needle with the needle you. If you choose this method, you will follow steps 2 and 3 with your draw needle, and then replace the oral steroids and sweating stretch is the abdomen. Can hold a lot of oil - very hard to the most convenient spot to description on how to inject most will find drawing in the side of the syringe notes where they apply:. In the chart below, we have listed each muscle group, of the syringe back until the desired amount is obtained; should only be used if injections are so frequent new areas are needed. In most all cases, a an additional site to rotate needs. Further, most will find drawing is more commonly used again, swabs are perfect for this decide to give it a.Make sure you're injecting in the right place The best places to inject are your glutes, quads and delts. It's easier to inject into these bigger muscles but. Steroid. Users. Injecting Sites. The following sites are the safest areas of the body to inject (please point between the knee and the top of your leg. Find a comfortable, well lit working place and inject at the same time each day. The thigh is a good place to give yourself an injection.